What does the security light mean on a 2003 Chevy Impala?

How do you turn off the security light on a 2003 Chevy Impala?

You’ll need to reset the anti theft system in order to get Your security warning light to shut off on Your dashboard. This will be done by putting the key in the ignition and putting the vehicle in to the on position and then turning it off.

How do I get my Impala out of security mode?

To reset the security on your chevy impala attempt to start the car. If it does not start, or dies very quickly after it started, then leave the key in the ignition in the “on” position and wait 10 minutes. Make sure the security light is flashing.

Why is my security light on?

Hello. On your particular vehicle the security light staying on as the vehicle is running is an indication that the security system has failed and is disabled. It is common for a security light to come on after battery dies because the computer may lose its programming to the key.

IMPORTANT:  Question: What are the types of protective alarm?

How do you reset the service theft deterrent system on a Chevy Impala?

Close the door and wait for the security light to stop flashing from inside the car. Another option is to close the doors first, and then press the “Lock” button on the keyleSSRemote. This will also pre-arm the theft-deterrent alarm system.

Can anti-theft stop car from starting?

Anti-theft systems are designed to prevent your vehicle from being stolen. These systems are constantly evolving. Essentially, they work via an electrical circuit disconnecting to prevent power from flowing so your car won’t start or will die immediately.

Does anti-theft light drain battery?

The anti-theft light won’t drain your battery. But, if you leave the car alarm to go off for long, it can drain the battery.

What triggers the anti-theft system in car?

The Anti-theft alarm system works with the help of sensors installed in and around the vehicle. An impact or the movements inside the car activates the sensors. This, in turn, triggers the Anti-theft alarm system and sounds the alarm. The alarm goes off and alerts the owner/people.

Why is my Impala not starting?

While there are a variety of reasons your Chevrolet Impala won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter.

How do I reset my Chevy security system?

How do you reset the Chevy Silverado’s anti-theft system? Insert the ignition key, put it in the on position, attempt to start the engine. With the key in that position, wait ten minutes. The security light will blink and go out.

IMPORTANT:  What are risk and protective factors in child development?

How do I turn my security light off?

Motion sensor lights are often easy to reset from your breaker panel.

  1. Step 1: Turn off the circuit breaker that controls your motion sensor lights. Leave it off for 30 seconds to one minute before flipping it on again.
  2. Step 2: Check your motion sensor lights. For some models, resetting the breaker is all that is needed.

How do I get my car out of anti-theft mode?

Step 1: Insert the key into the door lock. Use the side door on the driver’s side and the physical key even if there is a keyless entry system on the car. Step 2: Turn the vehicle key to unlock the car door without releasing it. Hold the key for 30 seconds in the position.

How much does it cost to reset anti-theft system?

Anti-Theft System Reprogramming

Reprogramming can only be done by a dealership technician using a factory scan tool, or by an authorized locksmith if you can find one who can do computer keys. The typical charge for this may be $75 to $150 depending upon how long the procedure takes.

How do I turn off anti-theft without key fob?

Ways to stop a car alarm without a keyfob

  1. Check your owner’s manual. Every vehicle is different. …
  2. Lock your doors. …
  3. Turn the car on. …
  4. Turn the ignition to on and wait. …
  5. Pull the fuse for the alarm. …
  6. Pull the wires for your alarm. …
  7. Disconnect the battery.